Jump to content

What connectors do you use to attach a large wire to a relay?


Recommended Posts

I am looking at the MS wiring diagram and it shows a 2/4 gauge wire attaching to the relay, but what female end do I need to for this to work? That seems like a massive wire to connect to a relay

 

Note that I am not using the stock relays, my car has absolutely 0 stock wiring. Everything is 100% new

 

 

http://i.imgur.com/EE0sxFB.png

Link to comment
Share on other sites

Yup just like the pic shows the fuse block

I believe I used 6 gauge to a stud then 10 gauge to a relay

then to a fuse block

Then like the fuse block in your pic for proper fuse amps.

16 gauge to most everything else.

 

my old fuse block

 

http://i139.photobucket.com/albums/q299/I-W/Mega%20Squirt/DCP_0327.jpg

 

 

The Blue connector 2 RED wires with the black bands are actually spliced farther up in to the harness.

i just ran one to a relay. then to ground.

 

 

 

http://i139.photobucket.com/albums/q299/I-W/Mega%20Squirt/12VoltPowerSource.jpg

Edited by importwarrior
Link to comment
Share on other sites

O2 sensor

 

http://i139.photobucket.com/albums/q299/I-W/Mega%20Squirt/o2wire.jpg

 

 

 

Fuel pump wire

 

http://i139.photobucket.com/albums/q299/I-W/Mega%20Squirt/FuelPumpRelaywire.jpg

 

 

 

 

other side of connector

 

http://i139.photobucket.com/albums/q299/I-W/Mega%20Squirt/FuelPumpRelayWire2.jpg

Edited by importwarrior
Link to comment
Share on other sites

 Share

×
×
  • Create New...