Jump to content

my custom dash project.


Convette
 Share

Recommended Posts

So I can't stand the dated look of the interior, so I'm changing it. Simple, light and only what I need to drive. Still working on details... digital rendering overlayed on to an image...then a little photoshop. more to come

 

http://i177.photobucket.com/albums/w239/johnboy9788/interior.jpg

http://i177.photobucket.com/albums/w239/johnboy9788/int4.jpg

Link to comment
Share on other sites

  • 4 years later...

I'm digging up this post from the dead, but Convette do you have more details about how you did this?

 

How did you bend the aluminum sheets, what thickness are they? What material are the two center pieces?

 

I am pulling my dash out this weekend to start on a custom one and any details would help a great deal

Link to comment
Share on other sites

If you check my build thread I might have some more info there. I'll have to check the thickness but I think it is 1/8th inch. I bent them on my fence post on my back yard..lol the center pieces are wood.

 

Dope, that is genius. Did you weld it together or how are all the pieces connected to each other and then to the body?

 

Went all through your build thread but didn't see much details on the dash

Edited by leesfer
Link to comment
Share on other sites

 Share

×
×
  • Create New...