RJ Posted March 11, 2008 Report Share Posted March 11, 2008 does anyone know the size of the fittings used on Oscar's ABS by-pass line. i know the part that threads into the master cylinder & proportioning valve is 10mm x 1.0 (inverted flare) but is the other end -3 or -4 AN? stupid me left the fitting in the master cylinder on my old car. Thanks, RJ Link to comment Share on other sites More sharing options...
Indiana Posted March 11, 2008 Report Share Posted March 11, 2008 Send it back to him then go to NAPA and get a 30" piece of brake line, Japanese 10mm STANDARD FLARE metric thread, costs about $4 bent it yourself then it looks stock afterwards. Link to comment Share on other sites More sharing options...
Casey_L Posted March 11, 2008 Report Share Posted March 11, 2008 you can just reuse your stock line and bend it around. you dont have to buy anything. Link to comment Share on other sites More sharing options...
RJ Posted March 12, 2008 Author Report Share Posted March 12, 2008 you can just reuse your stock line and bend it around. you dont have to buy anything. my stock line is not usable. i did not take any care when removing it because i had the braided bypass line already (had it for 3 years on my 89). however, after removing everything from my new 88, i realized i had left on of the AN fittings screwed into the master cylinder on the 89, which went to the junk yard last year. Link to comment Share on other sites More sharing options...
Recommended Posts