Jump to content

boostinmini

Members
  • Posts

    382
  • Joined

  • Last visited

Profile Information

  • Interests
    G54b, 4G63, anything mitsubishi especially pre 2000s, custom fabrication and mountain biking.
  • Location
    Calgary, Alberta
  • Gender
    Male

Previous Fields

  • Zip Code
    t3c0n6
  • Model
    Other
  • Type
    Other
  • Model Year
    Other
  • Interior Color
    Black
  • Status
    On the road

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

boostinmini's Achievements

Rookie

Rookie (2/14)

  • First Post Rare
  • Collaborator Rare
  • Week One Done Rare
  • One Month Later Rare
  • One Year In Rare

Recent Badges

5

Reputation

  1. Looking specifically for a iacv for a 92 mighty max 2.4. Any one who might have parts from a 4g64 swap might have this.
  2. What about porting, where are good areas to improve flow
  3. Looking to do some exhaust housing porting on a Starion 8cm turbine housing. It has all ready been machined for a td05h wheel now just want to get the most flow of if this housing. Any one ever unbolt that three bolt waste gate flap and let it have it's own pipe into the exhaust like a dsm?
  4. Ok guys thanks for the help, I found a sweet deal on a brand new mhi 19c and td06 compressor housing so should make a decent turbo for the price
  5. So the back plate sizes are the same where the c clip hold it on?
  6. Ok here is another question, can compressor housing swap between td05 and td06 bearing sections?
  7. Ok, this is good to know, s do the spool of the td06 is not too bad compared to a td05?
  8. Sold out at the moment, pm if there is interest in more?
  9. I find this awesome but hard to believe. So I can buy a full td06, machine my td05 and slide the td06 in and the band clamp and everything fits?
  10. It's a whole td06 turbo, not just the wheel, it will all fit once machined?
  11. Looking at td06 turbo wondering if I got the Starion exhaust housing machined would it fit? Or td06 center sections are just to big?
  12. That deff helps but does not seem to show exactly what I am wondering
  13. Plumbing in a Starion engine into my might max and was wondering if some one had a coolant flow diagram? I believe its correct but I have no heater core heat
×
×
  • Create New...