-
Posts
31 -
Joined
-
Last visited
About TadsQuest
- Birthday 03/26/1995
Contact Methods
-
Yahoo
tadjohnson_82@yahoo.com
Profile Information
-
Location
BSL, NC
-
Gender
Male
Previous Fields
-
Zip Code
28461
-
Model
Conquest
-
Type
TSI
-
Model Year
1987
-
Transmission Type
Manual
-
Factory Color
California Red
-
Interior Color
Black
-
Status
On the road
TadsQuest's Achievements
Newbie (1/14)
0
Reputation
-
Still for sale?
-
Just a tip: when searching this site go to google and type in what you want with "starquestclub" after it. For exanple, "abs delete starquestclub"
-
Check the vacuum line inder the fpr to the throttle body, it should be dry. If theres gas in it the diaphragms bad
-
Check the vacuum line inder the fpr to the throttle body, it should be dry. If theres gas in it the diaphragms bad
-
I got it fixed it was the CTS, thanks!
-
Dad sells the pair, but they aren't push to release http://www.enginemachineservice.com/conquest.html
-
Alright so I hooked a 300ohm resistor to the CTS plug and it didnt help, it didn't change it at all. Also I checked the plugs and they were completely dry, not black, and did not smell like gas. Any other ideas would be helpful. Thanks again. Also the bog i'm talking about under load is the boost gauge (stock) going up to zero but low RPMs, as if I was going up a hill.
-
Dad also sells this rebuild kit. I think his site is enginemachineservice.com
-
Okay ill try it, thanks for the help Bill. If it was too rich would it cause it to bog under load like it does?
-
The problem is, i need the plug to think its not at operating temp, so it will tell the ecu to give it more gas.
-
Thanks ill try it asap. And indiana why would i do that when my idles fine at operating temp.? Its specifically when coolant is cold.
-
Also if its been sitting in the sun for a while and i start it up its fine, its only when the engine temp and outside temp is cold.
-
I havent checked it but it should be good cause if i keep my foot on the gas a little it stays running, only if i let off it stalls.
-
I had same problem and had my turbo rebuilt, cleared it right up
-
When does it not start up? Just if its sat for a while? If you let it warm up and shut it off will it start right back up?