Jody1 Posted December 14, 2014 Report Share Posted December 14, 2014 Guage is too deep for circuit board , etc Only write up I've found is for TEP . Thanks Link to comment Share on other sites More sharing options...
importwarrior Posted December 15, 2014 Report Share Posted December 15, 2014 i dont think i have seen one in a long time.maybe starquest.i-x.net Link to comment Share on other sites More sharing options...
Jody1 Posted December 15, 2014 Author Report Share Posted December 15, 2014 I haven't seen one on i-x. Yeah, it's been a while since I've seen one. Link to comment Share on other sites More sharing options...
Squrlsquash Posted December 15, 2014 Report Share Posted December 15, 2014 (edited) i did it, just had to file down the metal bezel on the gauge a bit to allow the clear plastic cover to screw back onto the instrument paneltep doesn't have a write-up, just a picture http://i1297.photobucket.com/albums/ag24/Squrlsquash/photo_zps815f7bc1.jpg Edited December 15, 2014 by Squrlsquash Link to comment Share on other sites More sharing options...
randy Posted December 16, 2014 Report Share Posted December 16, 2014 What steering wheel is that? Link to comment Share on other sites More sharing options...
Squrlsquash Posted December 16, 2014 Report Share Posted December 16, 2014 nrg suede deep dish pizza something or other took alot of research to find one that didnt look like crap (in the sub $100 range) Link to comment Share on other sites More sharing options...
mstieg Posted February 18, 2015 Report Share Posted February 18, 2015 If done right and carefully you can Rotozip out the white plastic behind the front panel to make room for a deeper gauge. Take off the green circuit board/sheet first and reconnect over the new one when it fits. Still have to file the bezel on front if continuing to use clear plastic cover. Mine broke from that too. GL Link to comment Share on other sites More sharing options...
Recommended Posts