Jump to content

Swapping a LS1 so got stock parts for sale


Menesing Drifter
 Share

Recommended Posts

Doing an LS swap in my car so as the parts come out they will be instantly for sale. Car was bought from a kid, then sat in this dude's yard for 4 years were it did not run until I bought it. Because of this I am not looking to make any real profit of these parts as the condition that they are in are pretty unknown. I'll be posting up things as I go and am also open to trades for parts I need. I will try to update this as much as possible. All parts are located in the South Florida area. I am excepting all and any offers for stuff!!

 

Things for sale:

Full motor assembly (Located in Fort Worth TX) $250

-everything is going to be included from the peddles, ECU, all accessories and even mounts. I have not personally seen it run but I did do a compression test when I took it out and it passed. It is an automatic

 

http://i48.photobucket.com/albums/f223/carsmart28/IMG_1150_zpsf563fbe3.jpg

 

Both front and back seats:****SOLD

 

Rear seat trim pad things that are on the back sides of the interior.*******SOLD

 

"Turbo" Seat Belts $30 shipped

-you will get everything

 

http://i48.photobucket.com/albums/f223/carsmart28/IMG_1224_zps4481cd2b.jpg

 

Stock Intercooler SOLD

 

 

Autometer Pro Comp Ultra-Light Boost gauge $55 shipped

-the kid had this in the dash in the place of the stock boost gauge, its in great condition

 

http://i48.photobucket.com/albums/f223/carsmart28/IMG_1217_zps3b03ec6c.jpg

 

Stock steering wheel tomorrow (one with the buttons on the bottom) $45 shipped OBO?

-make me an offer

 

http://i48.photobucket.com/albums/f223/carsmart28/IMG_1271_zpsa127d54e.jpg

 

Stock brake peddle $20 OBO shipped

-make me an offer

 

http://i48.photobucket.com/albums/f223/carsmart28/IMG_1270_zpsc32b08b0.jpg

 

New in box NAPA lower control arm bushing (for front) $30 shipped

 

http://i48.photobucket.com/albums/f223/carsmart28/IMG_1273_zps5ac07d06.jpg

 

http://i48.photobucket.com/albums/f223/carsmart28/IMG_1272_zpsad46579b.jpg

 

 

 

Things I need:

Blinker/Brights Stock

Edited by Menesing Drifter
Link to comment
Share on other sites

I might be interested in the front seats if you are willing to ship. I really only need the drivers side though. Let me know if you don't mind shipping. I know it would probably be in PITA. I do know there is a thread on here that shows how to disassemble seats for shipping. Edited by LSQuest88
  • Like 1
Link to comment
Share on other sites

FYI i am selling my LS1 swap parts (the driveline has sold localy) I have moddified cross member to mount 240sx rack and clear a gto pan, hooker headers with full exhaust, fuel pump/filter/regulator/lines/fittings, trans mount, driveshaft, tilton clutch master etc. I will be posting it in the for sale section shortly
Link to comment
Share on other sites

FYI i am selling my LS1 swap parts (the driveline has sold localy) I have moddified cross member to mount 240sx rack and clear a gto pan, hooker headers with full exhaust, fuel pump/filter/regulator/lines/fittings, trans mount, driveshaft, tilton clutch master etc. I will be posting it in the for sale section shortly

 

 

I think I might love you..... I was gunna have to fabricate all that stuff so yes please let me know!!!

Link to comment
Share on other sites

Looking to sell the fusible link box that's located next to the battery?

 

Send me a picture and I will let you know if thats for sale!

 

I might be interested in the front seats if you are willing to ship. I really only need the drivers side though. Let me know if you don't mind shipping. I know it would probably be in PITA. I do know there is a thread on here that shows how to disassemble seats for shipping.

 

Not really looking to split up the seats, Its hard enough as it is selling seats from a car know one really has or knows about yah know? I have shipped seats before and it was bloody expensive....

Link to comment
Share on other sites

  • 3 weeks later...

What year car is the engine from?

 

Is the engine still attached to trans? I could make the trip to pick everything up, but don't have the ability to take them as one unit. Need separated.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...