stock cam questionsstock cam
Posted 06 March 2017 - 07:56 PM
I have a rebuilt njv head I'm going to put in the wife's 86. Have a new short block I'm putting together for it. Head came with no cam.
I can use the one in her car which has about 130,000 miles on it, or drop in the schnider 284 I have or order one from ebay.
Look at this on eBay http://www.ebay.com/itm/172255344368
The ones on ebay say stock but show a 292 lift??? Way too much imo for stock.
Also, Dad has a listing for a stock cam (out of stock) that showes for turbo and non-turbo. I thought they were different grinds.
Posted 06 March 2017 - 07:58 PM
I can upgrade your Fuel Injection Pro firmware
Performance Coatings! Pistons, manifolds, bearings and more!
Now a graduate of EFI University! www.efi101.com
ECU Vendor link: http://www.starquest...howtopic=137426
Posted 06 March 2017 - 09:34 PM
Posted 07 March 2017 - 05:35 AM
Posted 07 March 2017 - 08:48 AM
Posted 10 March 2017 - 10:59 AM
1989 Chrysler Conquest TSi (Project Race Car) Build thread http://www.starquest...opic=147910&hl=
2001 Pontiac Grand Prix GTP (Daily Driver)
2003 Chevrolet Suburban 2500 8.1 To tow the two hay burners
1998 BMW 528i 5 Speed because the Suburban gets 10 MPG
Second place is S*** place , eh. - Stéphane Peterhansel
Posted 10 March 2017 - 01:26 PM
His: Durban maroon with 351w
Sophia white MS2 full sequential with BW S257sxe in the middle of a full tear down
Hers: Red restored and on the road, mostly stock
Posted 10 March 2017 - 04:22 PM
B-71 87 TSI ~ RIP
Black 87 Starion ~ Mess SOLD!!!
Proud New 89 slightly Rusted Fiji Owner !!!
The Ark was built by amateurs , the Titanic was built by Professionals.
Posted 10 March 2017 - 07:04 PM
This was answered in PQ's write ups. I believe there was a stamp or something on the shaft. Or you could just roll the dice and run one.
Think about this, unless the lift is different, the durations are probably really close between hydraulic and mechanical. There were valve length differences so it is probably more of a lift difference. If the transition from mechanical to hydraulic setups coincided with the change in valves, then to tell the difference you could measure camshaft lobe height and compare it to a known hydraulic or mechanical camshaft.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users