Jump to content



Body Panels


  • Please log in to reply
5 replies to this topic

#1 Ressurect1on

Ressurect1on

    Member

  • Members
  • PipPipPip
  • 90 posts
  • Gender:Male
  • Location:KC, MO
  • Model:Conquest

Posted 06 October 2019 - 07:32 PM

Not sure if this is being posted in the correct section, if so, mods please move to correct section.


doing a quick glanceover of my soon to be project i noticed rust under the paint on the driver rear quarter, my question is, are replacement panels/panel sections still available for the widebody variations of this car? if so is there a link to a website where?





#2 Turbo Cary

Turbo Cary

    Established Member

  • Members
  • PipPipPip
  • 1,770 posts
  • Gender:Male
  • Location:Charleston, South Carolina
  • Model:Conquest

Posted 06 October 2019 - 08:16 PM

You'll have to find one that is in decent condition and weld it to your car. Get some spot weld removal bits and a seam splitter. I would recommend a body shop to do the install if that's the route you choose.

Or you could fill the rust and shape the panel. Cut and weld in just a small section. Depends on how bad the rust is and how far it goes.

Got any pictures of it?

#3 kev

kev

    Moderator

  • Moderators
  • PipPipPipPip
  • 5,033 posts
  • Gender:Male
  • Location:PA
  • Model:Other

Posted 07 October 2019 - 10:03 AM

Unfortunately no.

#4 Ressurect1on

Ressurect1on

    Member

  • Members
  • PipPipPip
  • 90 posts
  • Gender:Male
  • Location:KC, MO
  • Model:Conquest

Posted 13 October 2019 - 08:22 PM

not at the moment, i moved the car out of the elements, but it's bubbling under the paint on the rear quarter where it bends outward at the bottom right behind the door.  i guess i could get some pipe to find the right bend and angle and do some panel fab, or maybe a ball peen with the right end would work with a metal shaping bag.

i've had to do some body work before on a chevy malibu so i already have a nice spotweld bit from snap on.

#5 BC_99

BC_99

    Plays in traffic

  • Vendors
  • PipPipPipPip
  • 5,233 posts
  • Gender:Male
  • Location:Concord, NC
  • Model:Conquest

Posted 14 October 2019 - 06:46 AM

I have a full right side 1/4 panel and some smaller patches available in NC, from wrecked cars that have been parted out. PM me to discuss.

BC
Steering coupler replacement U-Joints are available here...
http://www.starquest...howtopic=145280

Posted Image Posted Image Posted Image

#6 Ressurect1on

Ressurect1on

    Member

  • Members
  • PipPipPip
  • 90 posts
  • Gender:Male
  • Location:KC, MO
  • Model:Conquest

Posted 05 November 2019 - 06:42 PM

would you have full left side (drvers ide) 1/4's by any chance?




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users