bha280 Posted May 22, 2014 Report Share Posted May 22, 2014 I got some Cosmo sleeve-overs and Mookeh pillowball camber plates installed. New tie rods, inner and outer, and new ball joints (the ones that bolt on the control arm) and have a pop when I turn in or back out of the driveway or parking spot. Question is: is there something that should go between the camber plate and the top of the sleeve-over (with the little metal tophat)? Doesn't look like any of the rubber bits from the stock setup will fit. Should I be looking at a different culprit? Thanks. Link to comment Share on other sites More sharing options...
jszucs Posted May 22, 2014 Report Share Posted May 22, 2014 Check that the nuts in the top are tight. The strut rod can turn and loose up. Happen to my backs twice and I got the clunk pop from it. If you bounce the car you can see them move up and down. Link to comment Share on other sites More sharing options...
Recommended Posts