OK guys, here is the deal. Later today I will put the hood up on a web page.
The hood you will see is my stock hood with the scoop stuck on it:) So there is a seam aruond the scoop that will not exist in the finished product.
The only reason I am teasing you guys about this is that I will make a much better mold if more than just I want one.
As I said, it will need to be trimmed and painted, and it will need pins top hold it down.
No options available.
I would love to hear opinions, good and bad. I do not have another stock hood to start from as far as making changes, but if everyone has the same comment, I might be able to scare one up for a mold. ( IE, if I get 20 people who say " Yeah, I love it.. but you gotta move the scoop back 8 inches.." )
OTOH, moving the scoop back gets it in an area of stagnant airflow and ruins any functionality...plus, you gotta seal under the nose and both sides to get negative underhood pressure and allow more air in. AS I saod, the primary function is to vent underhood heat when stopped.
http://www.nuclearchicken.com/quest
These are *huge*
So besides the seam, what ya see is what you get.