questtuner82 Posted November 29, 2014 Report Share Posted November 29, 2014 Ok so my buddy has a 2nd gen eclipse that was caught in a 12 car pile up, he has 3 sets of coilovers and sleeves. Was wondering if they would fit quest struts? Link to comment Share on other sites More sharing options...
TexasQuest Posted November 29, 2014 Report Share Posted November 29, 2014 Nope. Link to comment Share on other sites More sharing options...
techboy Posted December 1, 2014 Report Share Posted December 1, 2014 Other than some sensors and electronic connectors there's not a whole lot of carry over between 2G's and Starquests. There's a few more things that are similar on 1G's and Quests, but again, not much. Link to comment Share on other sites More sharing options...
importwarrior Posted December 1, 2014 Report Share Posted December 1, 2014 if your just talking about the sleeve fitting our lower front strut to press on and weld up.like our D2's ???if so you need to just use calipers and measure ID of sleeve and OD of strut. if that fits you then need to figure out the top mounting of the strut. Link to comment Share on other sites More sharing options...
questtuner82 Posted December 5, 2014 Author Report Share Posted December 5, 2014 No these are just the coilovers like the cosmos for our car just the springs and the sleves u slide on ur stock struts that allow u to adjust ride height Link to comment Share on other sites More sharing options...
Recommended Posts