Front Tri Bar set: $350 shipped
Rear strut bar $150 shipped
Front and Rear set $468 shipped
Hey Gang, here it is, the Front Tri-Strut Bar some of you have asked me to make. As of now they are unpainted to show workmanship. The new Tri-Bars are made of 3/16 thick 6061 polished aluminum. Brackets are made of 3/16" and 1/4" industrial grade steel; they are laser cut and tig welded for strength and a clean finish. All fasteners are grade 10.8 steel. This is definitely a handling upgrade which helps to reduce chassis flex and roll while cornering.
Just to recap, the old Tri-Bars that were available more than ten years ago did good; they were made from lesser 6063 aluminum (electrical conduit) and mild steel.
Larger firewall base plate with 2 optional bolt holes for additional fasteners. Two self tap-in screws will be supplied or the upper firewall can be drilled for threaded screws using the wiper linkage access panel above the brake booster. The old Tri-Bar only had a small bracket and a single screw that held it to the firewall.
*******Anyone who has purchased a single bar from me can upgrade to a Tri-Bar. All I need is the front brackets sent to me. It will be modified and repainted along with the angle bars. The same cross bar that go across the strut tower will be reused. I will split the difference in terms of price. Cost to upgrade is $210 shipped *******
Strut bars are not DOT approved, use at own risk.
Edited by DieHARDmitsu., 06 January 2020 - 10:03 PM.