Jump to content

Solid rear subframe bushings


Recommended Posts

  • 3 weeks later...
We do not need to reuse the inner bushing or the outer two shells. I need the I.D. of the bushing and the I.D. of the frame where this bushing will go with all the material cleaned out so I can finish these I already started. I have a feeling that I need to measure a subframe in hand myself so I can fine tune the cut. Hopefull make a nice tight fit with minimal sanding if any. I just dont have one laying around. Edited by Laodicea
Link to comment
Share on other sites

I have a rear subframe i could measure or hack one end off and send to someone.

You guys know there are a few places that will make the bushings in super hard urethane. If you got enough group buy interest it would be worth it.

Edited by JohnnyWadd
Link to comment
Share on other sites

  • 2 months later...
  • 3 weeks later...
  • 5 months later...
 Share

×
×
  • Create New...