Jump to content

jayfressh

Members
  • Posts

    111
  • Joined

  • Last visited

Profile Information

  • Location
    Cleveland Ohio
  • Gender
    Male

Previous Fields

  • Model
    Conquest
  • Type
    TSI
  • Model Year
    1987
  • Transmission Type
    Manual
  • Factory Color
    Rio/Mexican Red
  • Interior Color
    Black
  • Status
    Being Modded

jayfressh's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. I have a known working Conquest 1987 manual transmission. Asking $125 pick up in Brunswick, Ohio. Located 20mi south of Cleveland, 20mi North of Akron. Reply, PM, or call 216-374-2268
  2. Deal, PM me a address to paypal.
  3. I am in need of a hood latch, the side that is bolted to the hood. Please reply with price shipped to Ohio 44212.
  4. $25 shipped I can send you a stock Mitsubishi wastegate actuator off a 14B.
  5. I have the cable uncertain if I have the plastic pull lever in the car. Let me check and get back to you, but I for sure need the hood latch.
  6. Looking to buy a hood latch, I need the latch that is bolted to the hood. Please reply with price shipped to 44212 Justin Kresty.
  7. Looking for the engine mount nut size, I tried a few different metric sizes 10x1.50, 10x1.25 etc... Possibly the stud top is just a bit banged up from swapping motors. Hoping I just have the wrong size, if not there will be 2 cross threaded studs after I jam these 1.50s on, and I'll just replace the whole mount next time around.
  8. What size AN how much? What do you need, I have more parts than what is listed DSM and StarQuest?
  9. 14B/G and or 16G waste gate actuator - $22 shipped 1g Eclipse/Talon/Laser blow off valve , crushed held 25psi strong with no leaks - $25 shipped L87-3 & L72-2 580cc injectors, from a 87-89 Conquest $22pc shipped Will trade as partial payment for aftermarket fuel pump, fuel pressure guage, oil cooler, 1g DSM AN fuel rail adapter.
  10. I have been coating over 5 years. I am not offering any services as I do not have time at the moment, I rarely get to work on my car being that I am always coating something for a friend. Wanting very badly to drive my car this summer, I have become selfish and made that my priority. I'd more than happy to answer any questions you might have, and I have some pictures of my work in a build thread on here.
  11. Cool red looks amazing, paint your interior trim pieces to match....
  12. I am a powder coater, and to answer the OP's question, yes. You can coat a block and timing cover. There is high temp powder that can be used, but I don't think it would be necessary for a block, and timing cover. It's debatable if a cylinder head would dissipate heat better, ceramic coated, polished, powder coated, or left as a raw cast/machined.
  13. Is there a preferred method of routing the throttle cable on 4g63 swaps? I've looked for pics but haven't found much short of one guy who rotated the throttle body 90* to get it on the outside of the intake. Are most swappers just cutting out the bend or bending it straight? Is anyone shortening the cable length? Thank you.
  14. 1st choice red, second choice whatever is cheapest. I'm just south of Cleveland, so Dad it looks like your about 1hr away, I'll give you a ring tomorrow morning. Thank you.
×
×
  • Create New...