Jump to content

Where to get prebent mandrel exhaust sections


Boosted_One
 Share

Recommended Posts

  • 2 weeks later...
You can also get U bends and J bends at jeggs or summit racing, I do know that jeggs has the U bends in 3" and are about $20.00 each with free shipping. I believe the web site for jeggs is www.jeggs.com, dont know about summit.
Link to comment
Share on other sites

If the shop has a mandral bending machine, they could bend a st8 piece of tubing to meet your needs.   However most shops do not have this machine and the ones who do will most likely charge more to bend them then it would cost to buy the bends from JC Whitney.

 

kev

Link to comment
Share on other sites

That roadraceengineering site is way overpriced.

Stick with JC Whitney for the same tube at nearly half the cost.

I did a complete 2.5" Mandrel exhaust from the turbo back for under $200. I did however just used a Pace Setter 2 1/2" Monza resonator tip for the muffler. 4" Pencil Tip.  It is louder, but flows very well, and sounds tough.

Tim C.

Link to comment
Share on other sites

  • 2 years later...
  • 1 month later...
You can also get U bends and J bends at jeggs or summit racing, I do know that jeggs has the U bends in 3" and are about $20.00 each with free shipping. I believe the web site for jeggs is www.jeggs.com, dont know about summit.

 

 

drop one g - www.jegs.com

Link to comment
Share on other sites

  • 2 weeks later...
  • 1 month later...
 Share

×
×
  • Create New...