Guest Posted May 4, 2002 Report Share Posted May 4, 2002 You know those bushing's that are on each side of the crossmember that the torque tube attatches to . Well , if you replace them fill them up with 998 black silicone let dry overnight and press them in . They have alot of hollow space in them allowing alot of movement . This will reduce the slapping of the crossmember to the body. The tranny mount also has alot of open area , filling this with 998 silicone will reduce engine vibration at the stick.... Peace Geo Link to comment Share on other sites More sharing options...
heefner Posted June 26, 2002 Report Share Posted June 26, 2002 I noticed the new rubber engine mount that I have is really soft. I was thinking of drilling holes and filling it with urathane or epoxy or something a little stiffer. How stiff is the 998 and where can I get it? Link to comment Share on other sites More sharing options...
86QUEST_TSI Posted July 15, 2002 Report Share Posted July 15, 2002 I used roofing urethane to make motor mounts for my Probe . If you fill real deep it takes a long time to dry though , but worked great . It is the only roofing urethane in a yellow tube and is where all the silicones are at Home Depot . I think it is Pro Line PL___ something or other . It is good stuff . Stiffening things up WILL transfer more vibrations to the interior ! But the mount was $65 each and the Urethane $3 a tube , 1 tube 2-3 mounts ..... Mike P.S. - The uses for this stuff are limited only by your imagination . Link to comment Share on other sites More sharing options...
Recommended Posts