Jump to content

seanc77339

Members
  • Posts

    28
  • Joined

  • Last visited

Profile Information

  • Location
    Humble texas

seanc77339's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. My new ovcp does not have a nipple for my single nipple external stock wastegate. Where does the end of this vacuum hose attach now??? Thanks, Sean :ph34r:
  2. I am looking for a car bra for my conquest...does anyone have a set for sale?? S =)
  3. I have tried the fuel pump jumper port on my 1987 flatbody and I do not hear the fuel pump turning on. It has been sitting for 2 months but it was running and functioning 2 months ago. The fuel pump is a year old. WHat could be causing this?? Sean
  4. THanks for all the help fellow starquesters. I stripped back both wires until I could see shiny metal and hooked them back up. Fingers crossed to see if that was the main cause. These cars are full of auto gremlins. SC
  5. it was a wiring short...had to cut back the secondary wiring harness a foot back just to get a signal. Noid light was a blessing in disguise. SC
  6. Plum crazy (barracuda) would look cool or even deep blue pearl (skyline).
  7. I have removed my secondary air cleaner. What is the purpose of the Purge control valve?? THanks again, SC
  8. I was wondering how is this gentleman at: http://www.cardomain.com/ride/331154/1990-mitsubishi-starion Is running his vacuum lines. I like how it is so clean in his engine bay. Any ideas on how he has accomplished this would be appreciated. Thanks, SC
  9. What is the best A/F wide-band meter available for our cars?? Thanks Sc
  10. I am looking for a set of running non leaking no cracked injectors to replace the high performance delphi injector set in my 1987 conquest (running way to rich and no boost). Preferably from 1987-89. Thanks for all the help, Sc
  11. 1. What happens if you block off the farthest and the second farthest nipple on the TB of an 1987 flat-body conquest while leaving only the first one close to the firewall still stock and connected?? SC
  12. I believe it is not working because the car hits a "hard wall" and will not accelerate (anymore) in first gear or any gear past the infamous 3K rpm mark. Thanks for all the help so far, SC
×
×
  • Create New...