avenger89

looking for a good stock turbo for my 88 quest, I have bigger injecters a Walbrow 225, so i could go a little bigger than stock let me know what you got. Oh yah... still using the stock manifold and TBI Just bigger injecters and a GEN 1 MAS.

Hey buddy, Thanks. But im not too sure if its the same either.. Anybody know?

Hey everybody! Looking for a hand crank for the moon roof on my 88 Quest. Let me know what you got. Thanks.

Hey all! Im looking for a throttle cable for my 88 Quest. let me know what you got.

Hey guys, looking for a TD05H compressor housing. just bought a 16g wheel and now i need the housing. let me know what you got.

Payment sent, shipping address is Justin Effertz 1035 modred street Lafayette Colorado 80026

done. do you have paypal?

Hey guys, Im looking for the mounting plate for the oil filter on my 88 Quest. the part that has the turbo oil feed line. let me know what you got and how much you want. thanks.

well I need it as soon as I can get it, I still have to pull mine too. PM me with what your thinking. Thanks again.

Looks like I jumped the gun and sent the last message without reading all of your post! 100.00 sounds good to me. Sorry about that. Do you still have the auto transmission? I need it bad! I can pick it up asap. Please send me a message if you still got it. Thanks again!

Hey, how much for the tranny? I live in Lafayette and can pick it up asap. Let me know, thanks

looking for a automatic transmission for my 88 quest. I will need it shipped to Lafayette Colorado, or if your in colorado i could pick it up. let me know what you got.

Hello, I'm looking for A Stock TD05-12a in good shape for my 88 Quest. Looks like mine is done for, I'm sure it could be rebuilt but it ate up the compressor blades and that wouldneed to be replaced as well. So if I could find a used one cheaper than the rebuild would be that would be great. Let me know what you got. Thanks.

Well I'm looking for 0.9v at the ISC after doing the adjustment to the TPS. I have bypassed the yellow/red wire to ground to lock the ISC in "perfect idle mode" and performed all the steps in the ISC/TPS procedure. But when testing the green + black - on the MPS I am only coming up whith .04v I can hear the ISC "zip" when the key is cycled. but under warmed up idle it takes a few seconds to drop the idle down after you bump the gas. I'm thinking that this is do to the low voltage. Thanks again guys.

Hey guys, I'm looking for a water pump pully. Let me know what you got and how much you want. Thanks all!