Compatible valve springs question.
Posted 27 May 2019 - 08:45 PM
This question is going to be a bit more for the older guys on the forum.
i know the installed height requirement for valve springs in 1.600, and the coil bind should be below 1.000
however where my question begins now is, what is the maximum diameter of the outer springs? as i have found some crowers with a 1.275 outer diameter coil bind @ .955 and a 338lb/in pressure rating, which should be better than the schneider dual springs.
has anyone else ran crower valve springs? or any other valve spring with this outer diameter or larger without a need for machining the head?
Posted 30 May 2019 - 04:02 PM
Posted 31 May 2019 - 08:34 AM
Part Number: 6610 Spring Type: Single Spring Quantity: 8 Outside Diameter: 1.235" Inside Diameter: 0.920" Installed Height: 1.600" Seat Pressure: 100 lbs Pressure @ .500": 180 lbs Spring Coil Bind:
You can't go much bigger OD than your retainer. Also watch the rising rate of spring pressure in looking for springs
Posted 04 June 2019 - 07:34 PM
Here is a link to the part:
knowing that the spring OD on factory replacement is 1.346 opens it up some. but it seems it still leaves it with sealed power or crower as the options. it also appears they have a 95lb spring seat pressure @ 1.600 so with a .500 lift it would be 264lbs at valve full open, which is about 80 lbs more then the schneiders springs. and 4lbs more then schneiders dual valve spring setup.
then there is this option, but the seated pressure @ 1.600 might be a bit excessive.
what do you think about these springs?
Edited by Ressurect1on, 04 June 2019 - 07:44 PM.
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users