Jump to content

Mazda TPS conversion for the Starquests


JAinsworth
 Share

Recommended Posts

Tutorial Alert! Please sticky in appropriate section.

 

OK fellas, Here is a quick run through for the installation of the Mazda TPS upgrade sold by Boostinmini.. This upgrade is a very good idea as anyone who has ever sweep tested a box full of Starion TPS's and not found a single good one will understand! The used Mazda TPS I got with this kit sweep tests perfectly.

 

First, you'll need to splice the Mazda TPS leads onto a stock TPS plug. The wiring diagram is below, there are a couple types of Mazda TPS's so two color variations are below.

 

http://waste-nj.com/d2/tps/tpsdiag.jpg

 

http://waste-nj.com/d2/tps/tpsdiag2.jpg

 

 

Here's the Mazda TPS with stock connector soldered on and wrapped.

 

http://waste-nj.com/d2/tps/tpsspliced.jpg

 

 

Here is the adapter mounted on the TB mixer. Nice O-ring mount. You will want to

cut a piece of the included adhesive foam and stick it behind the adapter to cover

the small gap between the adapter and the stock mount.

 

http://waste-nj.com/d2/tps/tpsoring.jpg

 

 

Here is the mounted Mazda TPS. It adjusts like the stocker. Take care when

installing it to make sure the notch in the TPS lines up with the pin on the throttle

shaft. Recommend using some blue loctite on the small nuts holding it on.

 

http://waste-nj.com/d2/tps/tpsfront.jpg

 

 

Here's a view from the top.

 

http://waste-nj.com/d2/tps/tpstop.jpg

 

Easy breezy! Good stuff.

  • Like 2
Link to comment
Share on other sites

 Share

×
×
  • Create New...