shinra ceo bman Posted June 27, 2015 Report Share Posted June 27, 2015 ok so i finally getting some time to work on my car, i need to upgrade my knock box from the stock 87 to the modded 88 89 for scott's standalone setup, could someone link me to a write for the knock box upgrade, plz thx Link to comment Share on other sites More sharing options...
87redcat Posted June 27, 2015 Report Share Posted June 27, 2015 Posted 07 February 2006 - 04:06 PMyour best bet is to get about 6" of wiring harness from the donor vehicle - then all the wires match up 1 for 1 and there will be two left over that you can just tape up the ends. If you are planning on cutting the connector that goes into the 87 box and wiring it directly... well, for one you won't be able to disconnect it, but it still will match up copied from a post from Turbo_Addict Link to comment Share on other sites More sharing options...
scott87star Posted June 27, 2015 Report Share Posted June 27, 2015 Solder everything, no wire nuts or butt connectors allowed or supported. Link to comment Share on other sites More sharing options...
shinra ceo bman Posted June 28, 2015 Author Report Share Posted June 28, 2015 Thanks guys, what threw me off was i didn't notice that wires before the plug where the same color Link to comment Share on other sites More sharing options...
polarisman14 Posted June 28, 2015 Report Share Posted June 28, 2015 If you are looking for one I have one available with pigtail. At one point I had one that Scott had modded too but that has since been sold. Link to comment Share on other sites More sharing options...
shinra ceo bman Posted June 29, 2015 Author Report Share Posted June 29, 2015 all I need is the pigtail already have the knock box thanks though Link to comment Share on other sites More sharing options...
Recommended Posts