Jump to content

Magna MPI intake gaskets


Recommended Posts

So I can make the stock gasket work from the head to the lower intake plenum but I need a gasket for the lower and upper intake manifolds. The search engine seems to be down but I think i have done this search before with no luck. I think i found a couple of master gasket sets that MAY have them but can't be sure and they want $60+ for shipping stateside, on top of that i would have create a AU Ebay account, i can't sign into my own.

 

This set maybe:

http://www.ebay.com.au/itm/PAYEN-VRS-GASKET-MITSUBISHI-CANTER-MAGNA-PAJERO-SIGMA-2-6L-4G54-DJ89B-P-/281311326491

 

This set is my best bet i think:

http://www.ebay.com.au/itm/Mitsubishi-Magna-TM-TN-TP-TR-TS-Triton-ME-MF-MG-MH-VRS-Gasket-Set-G52B-G54B-/291149671533

 

Has anybody found another solution?

Link to comment
Share on other sites

Last time I had mine apart the gasket tore so I ended up tracing it on to some universal gasket material and then cut it out with an exacto knife.

Any chance you can do a rough outline of the flange and trim to fit?

Link to comment
Share on other sites

just get a roll of gasket material. ( autozone, advance, PEP Boys)

trace it out and cut some holes with an exacto knife or something.

your kids would have fun making this gasket. if you have any.

Edited by importwarrior
Link to comment
Share on other sites

  • 3 months later...
  • 11 months later...
 Share

×
×
  • Create New...