BKB94 Posted December 16, 2023 Report Share Posted December 16, 2023 Mitsubishi loved brackets and 10mm bolts, this is a fact. I'm missing something here to attach the hood latch support to the chin spoiler, what did it look like? Link to comment Share on other sites More sharing options...
techboy Posted December 16, 2023 Report Share Posted December 16, 2023 If I remember right I think there was a c-shaped clip that went around plastic of the chin spoiler and attached to that mount point. You don't really need it though. Pretty sure on my car I cut that latch support flush with the bottom of rad support with a sawzall. Link to comment Share on other sites More sharing options...
BuGG Posted December 16, 2023 Report Share Posted December 16, 2023 That threaded hole on the bottom of the hood latch support and the stud in the center of the lower bumper spoiler are attachment points for the plastic underbody splash shield. Link to comment Share on other sites More sharing options...
BKB94 Posted December 16, 2023 Author Report Share Posted December 16, 2023 OK, I do have the metal under car shield and that thought did enter my mind. I will need to see if it has the holes that align up. Mitsubishi logic just doesn't jive with mine. I want to do some aero on this car, wish I kept the front clip to make some fiberglass panels. Want to funnel the air from the bumper opening into the rad and do a better job of directing air. 2 Link to comment Share on other sites More sharing options...
Recommended Posts