Jump to content

LS swap motor mounts


rrperez10
 Share

Recommended Posts

Also if you go that route, take a cereal box and trace around those tabs and cut out 4 of them. These work great for templates to trim until you get it to where they fit nice. Make sure to label which ones they are, driver front driver rear etc... Then take the final pieces and trace them over the actual metal tabs. That will make sure you only have to cut them once and they will be right. Make sure the actual mounts are on the engine and it's set in place where u want it when u go to test fit and trim the cardboard pieces. Hillbilly way of doing it but it works damn good
  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...