Jump to content



Fidanza Installation info


  • Please log in to reply
No replies to this topic

#1 mstieg

mstieg

    Advanced Member

  • Members
  • PipPipPipPip
  • 6,115 posts
  • Gender:Male
  • Location:Fort Myers, FL
  • Model:Starion

Posted 17 April 2013 - 10:15 PM

An old but good write-up on getting an alum. Fidanza resurfaced recently.  Old hat for some, but I didn't see it as a sticky, Trans/Clutch/Drivetrain FAQ, or in the Engine & Performance Mods forums.

If the OEM dowel is a bit loose, the 10x24mm Fasenol dowel part # is:  40079 to go into a new hole via a 25/64" drill bit.

http://b2600turbo.co...um_flywheel.htm
Before: 352 rwhp @15psi; MPI: SDS EM5F; Chad intake & equal length header; S256 turbo (56/80comp-64/74ex); 48" of 2.5" IC piping
Now Done:  7.5:1 .35 Wiseco rebuild w/ crank scraper; 274 Magna roller cam & 1.55 rockers; mod port AMC head; 1mm>valves; Innovate WB; GM alt/rewired; 3" 240 alum radiator, elec fans; BMW X5 oil separator exh. crankcase vent; gas tank renewed; D2s; sway/strut bars; LT1 T56 clutch & trans swap w/ Fidanza; 4.22 rear; 265 Kumos on SHP rears; new steering pump/box/lines & coupler fix: http://www.starquest...howtopic=139558; full dash/console rewire - Autometer, push start, etc.
In Progress: breakin & tune
Future: Enjoy driving again; meets & local shows; AC; WG reroute from open vent to exh; Water/Meth?; body/paint

FOR SALE:  Rear Camber plates (basic); NIB beefy U-joints(2); etc.see-->  http://www.starquest...howtopic=133262 Custom 5 gauge overlay panel: http://www.starquest...pic=136703&st=0








1 user(s) are reading this topic

0 members, 1 guests, 0 anonymous users