Jump to content

Subaru/ Toyota W and R series trans adaptor


Bill Hincher
 Share

Recommended Posts

I can get back to building housings now, I been doing a lot of R & D time

 

http://www.billsautofab.com/images/01Subw55.jpg

the details are worked out, the wall thickness is ok and the draft angle is worked out on both sides of the housing, this should shrink about 1% and then I will test machine out a raw casting and it should all be good

 

http://www.billsautofab.com/images/subtoyadaptor106.jpg http://www.billsautofab.com/images/subtoyadaptor107.jpg

http://www.billsautofab.com/images/03Subw55.jpg http://www.billsautofab.com/images/08Subw55.jpg

 

http://www.billsautofab.com/images/subtoyadaptor108.jpg http://www.billsautofab.com/images/subtoyadaptor109.jpg

http://www.billsautofab.com/images/subtoyadaptor3.jpg http://www.billsautofab.com/images/10Subw55.jpg

 

 

http://www.billsautofab.com/images/subtoyadaptor110.jpg http://www.billsautofab.com/images/subtoyadaptor111.jpg

 

http://www.billsautofab.com/images/subtoyadaptor8.jpg http://www.billsautofab.com/images/subtoyadaptor10.jpg

 

 

http://www.billsautofab.com/images/subtoyadaptor112.jpg http://www.billsautofab.com/images/subtoyadaptor113.jpg

It goes to the casting shop Monday

http://www.billsautofab.com/images/subtoyadaptor114.jpg

Link to comment
Share on other sites

 Share

×
×
  • Create New...