subzerodata

Hello do I have to do mods to this board for edis IGN advance? Found online a mod removing c30 etc or is this for V3.0 only... Thanks

ok thanks, so should I use tps and map and not speed density? Or speed resort is fine for my setup? Found the factory resistor pack of my car can these work ok or do I need to buy new pack of 6 ohm?

Thanks this is exactly with what I've struggled so far. It has been really frustrating .To make matters worse There is a difference with the AFR gauge and the reading in tunerstudio about 1.0 I'm using innovate lc-1

Nevermind found it in the service manual thanks

How about the fuel regulator is that supposed to be connected vacuum -34kpa at idle or before the tbi where kpa is at 99 when idle?

Ok will give it a look today, thanks.

I have 1 650cc and 1 950 both ara about 2.4 ohms what value should be correct for me?

I'm using the megamanual diagram...Scott told me about 10ohm 25watt resistor I will verify if I can buy 2 from eBay...thanks.

I'm a little confuse regarding this issue I will read a little more when I get Internet at home...still waiting for the installation..If you have inj carasteristics settings for low resistance injectors let me know...I'm running trilogy turbo injectors...I just don't want to cook them...thanks...

Ok guys, thanks for all your help...I'll keep trying till I get it right...now will search for resistor pack since my injectors are 2.6 ohms any idea as where I can find a compatible resistor pack.. Thanks again...

Not map table I mean map kpa on the VE table sorry...How about the correction should that be 147 -47?

Changed vacuum lines to the nipples under the throttle before with power on but car not running it reads map 99.1 when the car is at idle does vacuum and the map chart and my boost gauge goes to -10 vacuum and thea chart indicates around 38kpa is this the way it shoul be or does it have to be at 99 with car at idle and boost gauge at 0? Thanks best regards, Leo.

Cool, thanks for your reply I'm using the map sensor built in Megasquirt and want to know the settings for it on tunerstudio.. I'm at 99.1 with the car off and at 477ft from sea level is this wrong? Thanks

Anyone know what is the correct settings for the map sensor? I don't see much variation on the map tables when applying 6psi. It starts at 99.8 and it only moves to 102. At that psi it should go up to? Anyone know?

Thanks Scott, as of now I'm using my IPod and works Internet... As soon as I get connection at home I will pm you and send you my file with my setup info.. Thanks again best regards, Leo.