Stedebani shifter instructions..
Posted 01 July 2017 - 01:52 PM
Does anyone have a digital copy or any kind of assistance...
It seems you use the factory shifter plate/boot/etc...according to these pictures:
Posted 07 July 2017 - 07:39 AM
Posted 07 July 2017 - 07:44 AM
I found it easier to grind out these crimps than cut the hardened shaft like the instructions say.
And last to punch out the dowel pin. This sucker is in there! Note that my plastic retainer (the ball that goes around the dowel pin) is completely gone! It must have disintegrated over the years and fell down into the transmission.
Posted 07 July 2017 - 08:29 AM
Here are some pics of the assembly. I'm missing a few because in between the time of punching out the factory dowel pin and installing the new one, I managed to mash my thumb into something with the hammer. To the point where I should have went for stitches, but instead continued on after wrapping it up. So I wasn't as focused from this point on.
Install the new retainer and dowel. Make sure the dowel is a press fit! You shouldn't be able to slide it in easily!
I only show the one gasket but there are four, two of the 3 bolt pattern and two of the 4 bolt. Pretty self explanatory where they go.
It looks like I never took the final pictures prior to reassembly but one thing that I did in addition to the instructions was add some pins to the aluminum block to align to the transmission. Note that the original rectangular plate has two dowel pins to index to the tranny. When adding the aluminum spacer, the spacer has holes to accept the dowels on the steel plate..maintaining alignment between the shifter and the plate. But there is nothing maintaining the alignment between the aluminum plate and the tranny! I wasn't comfortable in the bolt hole slop controlling alignment so I added two M5 roll pins. I think they were around 1" long. Hammered them into the aluminum plate until they contacted the dowels on the steel plate above. Then cut them so they protruded from the plate about 3/16". Had to use the four bolts to press in the pins on assembly to the trans which will make removal a bit of a job but I felt it was worth it.
Posted 10 July 2017 - 12:57 AM
Now Done: 7.5:1 .35 Wiseco rebuild w/ crank scraper; 274 Magna roller cam & 1.55 rockers; mod port AMC head; 1mm>valves; Innovate WB; GM alt/rewired; 3" 240 alum radiator, elec fans; BMW X5 oil separator exh. crankcase vent; gas tank renewed; D2s; sway/strut bars; LT1 T56 clutch & trans swap w/ Fidanza; 4.22 rear; 265 Kumos on SHP rears; new steering pump/box/lines & coupler fix: http://www.starquest...howtopic=139558; full dash/console rewire - Autometer, push start, etc.
In Progress: breakin & tune
Future: Enjoy driving again; meets & local shows; AC; WG reroute from open vent to exh; Water/Meth?; body/paint
FOR SALE: Rear Camber plates (basic); NIB beefy U-joints(2); etc.see--> http://www.starquest...howtopic=133262 Custom 5 gauge overlay panel: http://www.starquest...pic=136703&st=0
Posted 10 July 2017 - 06:37 AM
Scotts the man! check out his store. http://www.starquest... My site provided by Natallica the sticker Guru http://nbingaman.wix.../gntperformance
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users