Draw Through TBI (Australia)
Posted 28 March 2017 - 01:00 AM
A bit of the history on the car
Started as a carby setup..
Built a draw through manifold..
Ford 65mm throttle body..
Wiring is always fun..
Made a surge tank with HP pump and regulator. Bolted it to the strut tower..
36-1 Crank angle sensor.
Ford EDIS coil pack.
Dual spark CDI.
4x 60lb injectors (running E85).
Flex fuel sensor.
TechEdge WideBand Oxygen sensor.
4 port MAC valve to control the wastegate.
GIZZMO Knock Sensor
S13 3 core Aluminium Radiator.
Starts and idles but have yet to tune it.
Wanting to finish the brake upgrade before I start road tuning it. No point building something that goes well, if you cant stop it ploughing into something..
Posted 28 March 2017 - 04:40 AM
B-71 87 TSI ~ RIP
Black 87 Starion ~ Mess SOLD!!!
Proud New 89 slightly Rusted Fiji Owner !!!
Posted 28 March 2017 - 07:35 AM
Lotsa cool stuff & effort in your build thread. Good 2 c 2.6 diehards
Posted 28 March 2017 - 08:36 PM
a.) To remove the need for an intercooler.
b.) Not to modify the original Sigma Turbo manifold (only around 400 ever made)
I have made/modified a few MPI manifolds, ie:
and will most likely use them in future builds, but I was curious to see how well this will go as a draw through.
The other major advantage is the evaporative cooling effect of the E85 as its going through the turbo, which is much like injecting water before the turbo. The air/fuel charge, while going through the turbo, actually cools the charge more than going through a medium size intercooler (in theory). Cooler charge means more air in the cylinders which equals more power.
It also mean less heat being blown back into the engine bay from the intercooler.
The main disadvantage of this setup is accuracy in the fuel delivery.
It's not BAD, it just can be better with port injection.
Posted 28 March 2017 - 11:58 PM
Zoom clutch, Fidanza flywheel, Stedebani shifter, KSport coilovers, ST swaybars, abs delete, a/c delete, cruise delete, JVE, BSEK, TEP steel brake lines, LSP braided cooler lines, CX Racing radiator, MK1 silicone hoses, MK1 pullies, *DM hard pipes & intercooler,14G turbo, ported exh. manifold, MAF Translator, 3.5" GM maf, Turbo XS RFL bov, *DM 3" exhaust, Cusco front strut bar, TEP rear strut bar, Enkei 92's, HKS turbo timer, AEM wideband, AEM boost gauge, AEM oil pressure gauge, SPA fuel regulator, Hallman boost controller
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users