Jump to content



Ressurect1on

Member Since 07 Mar 2019
Offline Last Active Jun 16 2019 03:57 PM
-----

Topics I've Started

Compatible valve springs question.

27 May 2019 - 08:45 PM

Hello,

This question is going to be a bit more for the older guys on the forum.

i know the installed height requirement for valve springs in 1.600, and the coil bind should be below 1.000

however where my question begins now is, what is the maximum diameter of the outer springs? as i have found some crowers with a 1.275 outer diameter coil bind @ .955 and  a 338lb/in pressure rating, which should be better than the schneider dual springs.

has anyone else ran crower valve springs? or any other valve spring with this outer diameter or larger without a need for machining the head?

thanks.

Forum Search Function

27 March 2019 - 09:01 PM

It appears the forum search function is currently inoperable, don't know who to reach out to, or other way to make aware, feel free to delete post if need be.

Harnesses for 86 Conquest

08 March 2019 - 06:05 PM

Long story short.

About 15 years ago i acquired a 1986 Conquest Tsi, And one day i had an unfortunate incident that cause the harness to catch fire after i was done driving the vehicle, it has been parked ever since and now that i'm older and in a better position, i feel it is time to try to resurrect it.  

the bad thing is i'm not sure at this moment what all harnesses where affected, and i don't have immediate access to the car at this time to check it,

i do know the harness on the firewall that goes to the MAP sensor ( along with any wires ran with it) on the 86 is toast, as well as the engine harness regarding where the injectors are, i also have a damaged wire from the relay/fusible link area   that i think caused the whole mess from being frayed and increasing resistance.

So i'm throwing this out as a feeler to see if anyone may have harnesses available so I can bring this car back from the dead.

Thanks.