Jump to content

windshield wiper replacements.


Preludedude
 Share

Recommended Posts

The pin in the wiper where the blade is supposed to connect to?

 

http://i1069.photobucket.com/albums/u467/tsi_tom/The%20Missouri%20Project/General%20Car%20Stuff/originalwiper_zpsf7dd51a4.jpg

 

http://i1069.photobucket.com/albums/u467/tsi_tom/The%20Missouri%20Project/General%20Car%20Stuff/conquestwiperarm_zps1348298b.jpg

Link to comment
Share on other sites

Thats really odd, mine are not like that. Mine have the rod attached to the wiper arm and I can go to any store and pick up a set. Hell I just bought a set of Rain-X ones from menards for 8 bucks each and walked out to the parking lot and installed them by hand.
Link to comment
Share on other sites

The pin in the wiper where the blade is supposed to connect to?

 

http://i1069.photobucket.com/albums/u467/tsi_tom/The%20Missouri%20Project/General%20Car%20Stuff/originalwiper_zpsf7dd51a4.jpg

 

http://i1069.photobucket.com/albums/u467/tsi_tom/The%20Missouri%20Project/General%20Car%20Stuff/conquestwiperarm_zps1348298b.jpg

 

Yes. Exactly this. How do I get pin out of that?

 

Edited by Preludedude
Link to comment
Share on other sites

probably has a little rust on it. there is a release on the wiper arm and the pin should come out. make note of which side is which. of course that could be why its stuck in the wiper
Link to comment
Share on other sites

They are like 2 bucks from rock auto. Maybe like 8 bucks with shipping and all for both.

Just get them when you order other stuff is what I did. Good deal imo.

Link to comment
Share on other sites

My car is running wiper arms off of a late 80s/early 90s Volvo- it's a better Shepherd's Crook design and easier to find blades for. I had CarQuest special order my rear wiper blade, which was exactly like what you have pictured. It was their "exact fit" line and came with the pin installed. All other cross references were sans-pin.
Link to comment
Share on other sites

 Share

×
×
  • Create New...