I think i see a little transmission oil from leaking from the back of my manual tranny right where it connects to the drive shaft AND a little leaking from the release fork boot. Im guessing this is just tell tale signs of needing new front input shaft AND rear output shaft seals? This probably would have been alot easier if it was just the output... Now i have to drop the tranny to do the job. Would over filling the oil cause this or anything else I could have overlooked. I had the tranny inspected and reconditioned a couple years back... i doubt they'd have overlooked any mard shafts and such... How much of a PITA is it to swap out both? thx guys.....