Jump to content



Community Status Updates


Turbo interceptor's Photo

Turbo interceptor

actually, I'm obsessed with diveing one!! lol
Jun 11 2017 02:33 PM
Turbo interceptor's Photo

Turbo interceptor

also bare with me still not sure how to fully use the site.
Jun 11 2017 02:18 PM
Turbo interceptor's Photo

Turbo interceptor

just became a member AKA Turbo interceptor, I have been trying to buy one for some time, but it's hard there either junk or 15k I have like 6000, I'm in North East ohio, please help me thanks justin, 4404944407
Jun 11 2017 02:16 PM
lampyguy's Photo

lampyguy

forgot password
May 30 2017 06:18 PM
mstieg's Photo

mstieg

Seeking a tuner for SDS with dyno. Fixing turn signals & O2 readings by SDS to match wideband #s. Donor AC condenser needed to reinstall AC this summer.
May 27 2017 07:56 PM
AshyBone's Photo

AshyBoneLaodicea

Hello, I have a question about doing a rack and steering swap to my 88 TSI. I tried to send you a message, but I can't. Is there anyway I can contact you?
May 16 2017 09:56 PM
NikoFab's Photo

NikoFab

“With each replacement of parts, a car slowly becomes Chinese.” ― Mr. Kuniyasu
Apr 25 2017 11:39 PM
Newdesigner2's Photo

Newdesigner2randy

I might have an 87 manual console are they same as 86
Apr 06 2017 12:11 PM
Newdesigner2's Photo

Newdesigner2

I am.parting out an 87 conquest no engine or trans available wheels are bent lips fenders are rough quarters are junk , doors hood and hatch are rust free, front seats dry rotted back seat fine black leather. I removed everything clutch related but I am in desperate need of the eye bolt that holds the clutch hose to the slave cylinder.
Apr 05 2017 09:15 PM
folklaur's Photo

folklaur

Can't wait for PF '17!
Mar 28 2017 11:43 PM
J-Martins4's Photo

J-Martins4

NEED DRIVERS SIDE FENDER 1988 conquest tsi
Mar 28 2017 02:44 PM
superscan811's Photo

superscan811

WHAT IS HAPPENING... UNABLE TO REPLY TO POSTS????
Mar 27 2017 12:14 AM
Bad2Rass's Photo

Bad2Rass

Getting ready for the Mountain lakes drive
Mar 24 2017 01:51 PM
navycajun67's Photo

navycajun67

Need advise. Pulled engine and torque converter is attached to flex plate. Engine is not siezed but had water migration to cylinders due to head gasket blowing. It sat idle for 4 years. Nor sure the engine will turn. Need to know the best way to remove torque converter. Engine will be rebuilt but dont want to induce any damage.....
Mar 20 2017 08:48 PM
NikoFab's Photo

NikoFab

"I hooked up my accelerator pedal in my car to my brake lights. I hit the gas, people behind me stop, and I'm gone." - Steven Wright
Feb 02 2017 11:32 AM